Failed to launch CCE ??

[Mugeb]

Hi !

I've finally registered today but when I use the prog i've that message during the propcess :

Failed to launch CCE

The prog is looking for the CC-SP Trial but I've selected the CC SP 2.50 in my settings. :confused:

Thanks in advance for your help. :)

[SpazzHH]

If you are using CCE 2.50, do you have DVD-RB set up correctly for it? Are you using and pointing RB to EclCCE?

[Mugeb]

Yeah, I've set it in the General Set Up (Path to CCE SP 2.5).

Does I miss something ?

Thanks.

[SpazzHH]

Are you pointing to EclCCE(correct) or CCE directly(incorrect) ?
And do you have EclCCE configured correctly?

[Mugeb]

Sorry.

But how I do that ?

I've just installed the prog and selected CCE SP 2.5 during the installation. It's installed in the the prog folder.

In the CCE Stettings the CCE SP 2.5 is selectionned.

What I've done wrong ?

[Fishman0919]

Well you have to have CCE SP 2.50 installed first, DVD-RB does not come with CCE SP. If you are using CCE SP 2.50 you must use EclCCE (LINK (http://forum.doom9.org/showthread.php?p=266080#post266080)). Unzip EclCCE where you would like and run EclCCE.exe, point to CCE SP 2.50 .exe file.... now....In DVD-RB, under settings, go to setup, set "Path to CCE SP 2.50" to EclCCE.exe. In DVD-RB under mode, Encoder, pick CCE. Under Setting, CCE Settings, pick CCE SP (v2.50)

[Mugeb]

Thanks for your help but I don't find the CCE SP 2.50 .exe. ???

I don't understand because I've selected it during the installation process it was supposed to be in installed in the prog folder.

What goes wrong ?

[SpazzHH]

CCE does not come with DVD-RB. You have to buy it separately.

[Mugeb]

Ah ok.

I didn't know that.

So what's the best ?


CCE Basic ?
CCE SP 2.7 ?
CCE SP2 ?

Thanks.

[on30trainman]

As SpazzHH says - DVDRB doesn't come with any version of CCE. If you want to use CCE, CCE Basic is the cheapest option - about $60 or so. The trial versions of CCE either put a watermark on or allow a very time limited amount of encoding. Use one of the included encoders instead.

Steve W.

[Mugeb]

I've the CCE SP2.

How I make it work with DVDRebuilder ?

Thanks in advance for your help.

[jdobbs]

If it is installed, DVD-RB will recognize it and it will be enabled in the CCE Settings Menu.