Pasqui
30th May 2005, 22:50
Change log
Build 23486 (1.6.6, experimental): [May 29, 2005]
[features added]
* Added an option in Options > Preferences > AVI to force sector alignment
for large uncompressed frames. This can resolve compatibility problems
with some uncompressed hardware video playback units.
[bugs fixed]
* Capture: Video/audio format and compression and video frame rate now
autosave on disconnect.
* Capture: Fixed some cases where the Raw Audio Format dialog didn't
highlight the currently selected PCM format.
* Capture: Noise reduction threshold was not restored properly.
* Capture: Renamed Peak Meter back to Volume Meter and restored V
accelerator.
* Frame byte size was being computed improperly for YCbCr AVIs.
* Fixed broken MJPEG video decoding at bottom-right corner on streams that
have restart markers.
* Reworked MJPEG field ordering detection to be consistent with DirectShow
MJPEG decoder. If this is reversed for your files, enable "swap fields"
in AVI extended open options.
* Scene detection was busted for 16-bit RGB (very rare case).
* Minor status updating features, such as the current position nub moving
during input preview, were broken after running a job that ended in an
error.
* (AMD64 only) Scene detection is now implemented.
* (AMD64 only) Enabled some video filters that had scalar implementations:
flipv, fliph, deinterlace, rotate, and HSV.
* Save Image Sequence dialog didn't show the "add as job" button as checked,
even if it was saved as such from the last time.
* Fixed minor bugs in various image converters and improved accuracy of a
few YCbCr-to-RGB converters.
* Fixed UYVY/YUY2-to-RGB converters not interpolating chroma properly.
* Fixed YVU9 chroma planes being swapped on write to disk and enabled YVU9
for direct input.
[regressions fixed]
* App would sometimes exit after stopping frameserver.
* Frameserver sent garbage data if the video filter chain changed the frame
size.
* Fixed a regression in video codec negotiation for MS MPEG-4 V3 variants
where a different but compatible codec was not properly detected.
* Doing a paste with no selection caused one frame to be deleted before
doing the paste.
* Write open failures were being reported again when the target file
couldn't be opened a second time in fast I/O mode, which happens
sometimes with emulators or remote drives. The slower fallback has been
reinstated.
* Running out of disk space at the very end of a render operation was
sometimes reported as an I/O error rather than a write error.
* Sampling in filter preview could fail if the timeline had been edited.
Build 23486 (1.6.6, experimental): [May 29, 2005]
[features added]
* Added an option in Options > Preferences > AVI to force sector alignment
for large uncompressed frames. This can resolve compatibility problems
with some uncompressed hardware video playback units.
[bugs fixed]
* Capture: Video/audio format and compression and video frame rate now
autosave on disconnect.
* Capture: Fixed some cases where the Raw Audio Format dialog didn't
highlight the currently selected PCM format.
* Capture: Noise reduction threshold was not restored properly.
* Capture: Renamed Peak Meter back to Volume Meter and restored V
accelerator.
* Frame byte size was being computed improperly for YCbCr AVIs.
* Fixed broken MJPEG video decoding at bottom-right corner on streams that
have restart markers.
* Reworked MJPEG field ordering detection to be consistent with DirectShow
MJPEG decoder. If this is reversed for your files, enable "swap fields"
in AVI extended open options.
* Scene detection was busted for 16-bit RGB (very rare case).
* Minor status updating features, such as the current position nub moving
during input preview, were broken after running a job that ended in an
error.
* (AMD64 only) Scene detection is now implemented.
* (AMD64 only) Enabled some video filters that had scalar implementations:
flipv, fliph, deinterlace, rotate, and HSV.
* Save Image Sequence dialog didn't show the "add as job" button as checked,
even if it was saved as such from the last time.
* Fixed minor bugs in various image converters and improved accuracy of a
few YCbCr-to-RGB converters.
* Fixed UYVY/YUY2-to-RGB converters not interpolating chroma properly.
* Fixed YVU9 chroma planes being swapped on write to disk and enabled YVU9
for direct input.
[regressions fixed]
* App would sometimes exit after stopping frameserver.
* Frameserver sent garbage data if the video filter chain changed the frame
size.
* Fixed a regression in video codec negotiation for MS MPEG-4 V3 variants
where a different but compatible codec was not properly detected.
* Doing a paste with no selection caused one frame to be deleted before
doing the paste.
* Write open failures were being reported again when the target file
couldn't be opened a second time in fast I/O mode, which happens
sometimes with emulators or remote drives. The slower fallback has been
reinstated.
* Running out of disk space at the very end of a render operation was
sometimes reported as an I/O error rather than a write error.
* Sampling in filter preview could fail if the timeline had been edited.