[VapourSynth] DctFilter

Mystery Keeper · 13th August 2014, 20:10

DCT Filter for VapourSynth r3
Source code

Only C routines are implemented now, so relatively very slow.

Usage:

dct.Filter(clip clip, float factors[8])

Performs DCT on 8x8 blocks of source clip, applies modification to it, then performs IDCT.
Modification is done as following: dct(x, y) = dct(x, y) * factor[x] * factor[y]

This filter does essentially the same as original Tom Barry's DctFilter for AviSynth, but does it differently.
All calculations are done on floating point values, and factors are applied as they are, not rounded.
Thus, the accuracy is higher.

Padding to mod8 is automatic for every plane, but cropping to non-mod16 values before applying this filter is impractical and shouldn't be done.

13th August 2014, 20:10	#1 \| Link
Mystery Keeper Beyond Kawaii Join Date: Feb 2008 Location: Russia Posts: 724	[VapourSynth] DctFilter DCT Filter for VapourSynth r3 Source code Only C routines are implemented now, so relatively very slow. Usage: dct.Filter(clip clip, float factors[8]) Performs DCT on 8x8 blocks of source clip, applies modification to it, then performs IDCT. Modification is done as following: dct(x, y) = dct(x, y) * factor[x] * factor[y] This filter does essentially the same as original Tom Barry's DctFilter for AviSynth, but does it differently. All calculations are done on floating point values, and factors are applied as they are, not rounded. Thus, the accuracy is higher. Padding to mod8 is automatic for every plane, but cropping to non-mod16 values before applying this filter is impractical and shouldn't be done. __________________ ...desu! Last edited by Mystery Keeper; 20th September 2016 at 21:35.