|
Hi Pel9,
noticed than when editing the PGs for a BD3D there is no change in the STN_Table_SS. This impact the link between PGs and respective 3D-plane numbers.
Was wondering it might be possible to implement such change so to generate a compliant mpls.
In my case I add some subtitle stream so would be convenient for me to find in the STN_Table_SS, for each new subtitles, a pre-set additional 0x FF 00. I can then change FF myself.
Changes should be the following, i/ Length of ExtensionData, ii/ Length of the STN_Table_SS, iii/ Starting point of the SubPath_entries_extension , iv/ remaining Length of the STN_Table_SS within the STN_Table_SS itself – sofar in all cases 2bytes per PG –, v/ include 0x FF 00 per PG (byte #23 of the STN_Table_SS onwards)
Hope t is possible and thanks beforehand in any case.
POFFO
|