Quote:
Originally Posted by Merlin7777
Yes, crf changed. But not in MeGUI, it changed in x264. Just run some tests and figure out what your new desired crf is.
Oh, and do you mean this:
because that's in you log.
The number of B-frames are in there as well. For example, 59.4% of the time you used 2 b-frames.
|
Hi merlin, thanks, about the note regarding the crf change (I'm aware this would be an x264 change, megui is just a gui), it appears 25 is now pretty similar to 20, at least for the video I was encoding.
Yes, I mean regarding the SSIM output. It was in my old log (the bottom one), it is now not outputting it into the log (I am using x264 1125 now I think and it's still producing the below error).
I am getting this:
Quote:
|
--[NoImage] Exception in readStdErr: Length cannot be less than zero.
|
If I encode the video from the command prompt I *do* get the output (SSIM, B frames, P frames, etc), but not in megui, I just get that error.
Thanks.