Doom9's Forum - View Single Post - GradCurve VapourSynth plugin port of virtualdub Gradation Curves plugin

xekon · 20th January 2017, 15:47

thanks for the reply

I do have it set to debug, but I don't think i had optimizations off, I opened project properties, went to c++ section then optimizations and set optimization to Disabled /Od

when you say single step, where would I access that? I see an option for "step into (F11)" however it skips over to the next defined break point.

I have also tried cleaning and rebuilding.

20th January 2017, 15:47	#53 \| Link
xekon Registered User Join Date: Jul 2011 Posts: 224	thanks for the reply I do have it set to debug, but I don't think i had optimizations off, I opened project properties, went to c++ section then optimizations and set optimization to Disabled /Od when you say single step, where would I access that? I see an option for "step into (F11)" however it skips over to the next defined break point. I have also tried cleaning and rebuilding.