EclPRO "Error" - Operation Halted

[TomBrooklyn]

1st time use and user.
RB ran for 4min 30seconds then stopped and window entitled EclPRO popped up.

It said:
EclPRO v0.42beta
An Ecl Loader for Canopus Procoder
Written by Robot1 - 2004/2005

I think I'm supposed to be using HCEnc. I just figured out Procorder was checked under Mode so I changed it to HC and started again.

Now it made it to .8% Overall Progress and then stopped. I don't know what to do now.

[SpazzHH]

1st time use and user.
RB ran for 4min 30seconds then stopped and window entitled EclPRO popped up.

It said:
EclPRO v0.42beta
An Ecl Loader for Canopus Procoder
Written by Robot1 - 2004/2005

I think I'm supposed to be using HCEnc. I just figured out Procorder was checked under Mode so I changed it to HC and started again.

Now it made it to .8% Overall Progress and then stopped. I don't know what to do now.
Well TomBrooklyn, we have so little information here that it's hard to know where to start. Did you use Rockas' installer when you installed RB? More importantly, did you rerun the "Prepare" phase after switching encoders?

P.S. Please list versions of RB, all encoders, avisynth, DGDecode, etc.

[TomBrooklyn]

Hi Spazz,
I figured it out, completed a backup overnight, burned a disk this morning and just finished checking it out and it came out good.

I had Procorder selected under Mode when it should have been HC Mode. That was the only problem. So all is well. Thanks. -Tom

[SpazzHH]

Glad to hear it and welcome to the Rebuilder Forum !!! :D