Log in

View Full Version : Red lines at the bottom from FAQ

caprioles9000
21st July 2005, 20:00
I seem to have the problem from FAQ Q4 which is:

"I set everything up -- but nothing seems to happen and/or I get video that is a black screen with orange/red lines at the bottom"

I have tried every possible method to solve it ......i have used dgdecode.dll and mpeg2dec3.dll.....the different versions of these but had no luck. I have tried it thru the setup button by changing path to decoder from dg to mpeg2...when both dfecoders were under the plugins folder and also the RB folder......i cant seem to figure it out. I am using retail version of CCE 2.67.00.27. I am using DVD-RB RC 2

I have also tried avisyth 2.5.5 and 2.5.4 ......still no luck.....anyone have any ideas???

Greetings
Caprioles9000
jptheripper
21st July 2005, 20:39
use the dvdrb installer

http://www.dvdrebuilder.com/
Carpo
21st July 2005, 21:03
as jptheripper says - use the install it will install the right version of dgdecode.dll that works with dvd-rb
Rockas
21st July 2005, 21:34
@caprioles9000
If you are using the PRO version... you should have got a Download link for the PRO Installer... if you use the Freeware version... use the Freeware Installer available on the Downloads section on the link jptheripper posted... or... check on my signature :D
caprioles9000
21st July 2005, 23:49
I have the pro version and I used the installer ..thats whats strange about it. Any other ideas ?
Rockas
22nd July 2005, 00:12
yes... unistall Rebuilder and AviSynth (it may got corrupted) and run the Installer again :)

Have you installed any software lately? dvd2svcd?
steptoe
22nd July 2005, 07:28
As suggested, uninstall DVD-RB and AVISynth, you must use the installer, it puts everything where it needs to be

Install AVISynth first though otherwise, unless its been included in the latest installer, the installer will stop and tell you that AVISynth isn't installed



The red lines across your output video is frequently a problem with filters used in avisynth, have you installed any filters and set them up in the filter editor. Some filters that avisynth can use need other filters installed as well to work correctly

Also make sure you are calling the filter correctly
caprioles9000
22nd July 2005, 11:03
Alright got it fixed ..it was simpky registry problems......I had already tried reinstalling a couple of times......i juts cleaned my registry with regvac and voila.....all works again ..thnx everyone :)