DVD-Rebuilder encoding problem

[drako]

Hi all,

I would like to know if anyone had or have the same problem as me.

What I am experiencing, is that after I prepare the movie for rebuilding, (using 3 click process) I get an encoded segment with garbage in it.

The steps I took are described below :

Installed AVISynth 2.55, CCE SP Trial 2.70, and DVD Rebuilder 0.80.

After everything installed, opend up the movie to be processed, and clicked on PREPARE.

After the PREPARE phase is finished, withou any warnings or errors, i clicked on ENCODE.

It starts encoding OK, no warnings and no errors, but when I open the encoded segment in PowerDVD, the segment plays garbage (FBI Warning) or with purple and pink colors scattered aroud (Company Logo Introduction).

When I open the AVS file with Media Player, the segment plays OK, without any problem.

Any ideas of what could be happening ???

Thanks in advance...

[Rockas]

That may be a bad installation, or a cracked version of CCE.

solution for first:
Use my installer

solution for second:
Buy CCE Basic or use one of the free encoders.

keep it UP

[archaeo]

If you're getting any part of a 'logo', it's not a full version.
CCE Basic is only 58 bucks, and it's running the same encoding engine as 2.70.

[drako]

OK...

Thanks guys...

Finally made it work...

Just rolled back DVD-RB version (0.79) with installer, and everything went fine.

Think was a problem with AVS file, but in the end, all is running smootly...

Wasn't a problem with the encoder after all... :-))

Thanks again for the input...