Searching for Scenarist Window; But error closed Scenarist.

[Fars33r]

I'm following this guide (http://www.doom9.org/mpg/scenaid.htm). After pressing go on DoItFast4U, everything became more or less automated. I followed the guide, however some error popped up (I didn't get the text; it seemed pretty random though; something wrong at sector (0x0004312***something))

In Scenarist Automation LOG it stopped after *waiting for compile to finish, and is now *Searching for Scenarist Window.

Are there any logs I could post to better show what's going on? Is there something I could do to make it resume, or should I start this over?

[Zeul]

at what point did the error occur? Was this after scenaid?
Did you use NuMenu4u - did this complete without error?
What version of scenarist are you running?

[Fars33r]

at what point did the error occur?
Right after it's done with CCE; the auto-scenarist starts up (I assume it's through scenaid), then it says it's looking for the scenarist window. The 2nd time I tried it an error opened asking me to manually close scenarist, which I did through Task Manager. Then I pressed OK on the error box and nothing happened.

Did you use NuMenu4u - did this complete without error? I used the exact process explained in the guide.

What version of scenarist are you running?
I'm using v3.0.1.121142



Weirdly; I tried to open DVD Scenarist manually, after DIF4U had been closed down, and it closed for by some error (no pop-up, just froze and windows error made it close). However when I tried a 2nd time it opened perfectly. I'm going to troubleshoot a bit; I'd hate to do this backup with DVD Shrink.

[techniquefreak]

Hi there Fars33r you should try Scenarist version 2.7 or no later than version 3.0. Later versions are known to be error prone with the big three. In short: to avoid a lot of hazzle you should "downgrade" your scenarist version to either 3.0 or 2.7.

Kind regards

Hansen