setting up dvd rb , for more than one cce.

[radar]

hello,im looking to set up rb to run two differant versions of cce.i have cce 2.5 and would like to install a newer version without removing the older one.im not sure where to put the newer version.:confused:

[archaeo]

Are you talking about installing a different version of 2.50.xx? If not, then you don't have to remove 2.50. RB offers three different paths for CCE: Basic, SP (2.66, 2.67, 2.70) and 2.50. Just place your 'newer' CCE version in it's own folder, and use setup to point RB to the correct folder (remember to use eclCCE when necessary). When preparing a project, just choose the newer CCE version under options/CCE.

[radar]

hi archaeo,
thanks for the info.do i have to use ecl for 2.70,im getting run time error 53.thanks

[gadh]

Originally posted by radar
hi archaeo,
thanks for the info.do i have to use ecl for 2.70,im getting run time error 53.thanks

No. ECL has no support for CCE 2.70 - but you directly link to the exe of cce 2.70 - it works great. but there is one problem ecl disables some Hotkeys of CCE an without this tool a hit on your space bar will close the encoding task of cce. so be carefully with you spacebar!

[archaeo]

Remember that you may have to modify the CCE Trial header in the Rebuilder INI for it to work, depending on the version you're using. If you look at the RB v.71 changelog, you'll see a note about this.

[radar]

thanks alot for your help,i finaly have it working.:)