zavar
5th February 2005, 23:29
I made a movie-only backup of the movie "Cube" using IfoEdit. I then tried to burn the files with Nero 6.3.1.10 on my NEC 3500 (Liggy&Dee's V2b6 firmware), using TYG01 discs.
When the burning process gets close to 28% percent, the Used Read Buffer empties and then fills up again. Burning gets stuck at 28% no matter how long I wait.
I tried this two times, one at 8X and one at 4X, with the same unfortunate result. Any ideas about what's going wrong?
P.S. I got an error message when processing the movie with IfoEdit. VOB not being the right size or something like that, but the movie plays fine from the hard disk.
When the burning process gets close to 28% percent, the Used Read Buffer empties and then fills up again. Burning gets stuck at 28% no matter how long I wait.
I tried this two times, one at 8X and one at 4X, with the same unfortunate result. Any ideas about what's going wrong?
P.S. I got an error message when processing the movie with IfoEdit. VOB not being the right size or something like that, but the movie plays fine from the hard disk.