CCE 2.7 problem. Opens then closes again.

[DMagic1]

I'm using RB 0.73 with CCE 2.70.01.05. My setup runs fine on my P4 system but on my AMD system there is a problem. After the preparation phase, when CCE starts, it will start for a quick second then close. RB will then go to the next cell. CCE will do the same thing over and over and over. It shows up for a quick second, doesn't run the avs, and then closes. I have the same setup on the other computer and it runs fine.

If I use CCE 2.66 it runs fine on both systems. Has anyone a clue about this problem?

[Sir Didymus]

Hi DMagic1! :)

Not sure it's your situation, but it seems only AMD athlon64 work with CCE 2.70...

http://forum.doom9.org/showthread.php?s=&threadid=88682

Cheers,
SD

Edit: or better it seems it does not work with old AMD processors [TBIRD core...]

[robot1]

Originally posted by Sir Didymus

Edit: or better it seems it does not work with old AMD processors [TBIRD core...] I can confirm it works with Athlon XP

[DMagic1]

Thanks guys. I was just reading that topic. I didn't come across it when searching. Oh well, hopefully a new version will come out or something.