runtime error 9 at start of rebuilding phase

[nick_harambee]

hello,

i am using DVD-RB (0.69) with CCE (2.66.01.07) in three click mode. the first two phases seem to go fine. but when i click on rebuild i get the following error message 'run time error 9: subscript out of range'. i am aware that this was an ongoing problem with previous versions of DVD-RB, but thought that this had been sorted. i have set up DVD-RB as per instructions on Doom9, installing AVIsynth 2.5 and DgDecode.dll and Decomb521.dll to AVI plugin folder. i am using a demo version of CCE so have installed EclCCE as instructed. does anyone have any idea what might be the problem here?

thanks

nick.

[dannyv]

Originally posted by nick_harambee
hello,

i am using DVD-RB (0.69) with CCE (2.66.01.07) in three click mode. the first two phases seem to go fine. but when i click on rebuild i get the following error message 'run time error 9: subscript out of range'. i am aware that this was an ongoing problem with previous versions of DVD-RB, but thought that this had been sorted. i have set up DVD-RB as per instructions on Doom9, installing AVIsynth 2.5 and DgDecode.dll and Decomb521.dll to AVI plugin folder. i am using a demo version of CCE so have installed EclCCE as instructed. does anyone have any idea what might be the problem here?

thanks

nick.

Ahh the old error 9 again. What dvd are you trying to do? Have you tried cce version 2.50.
I've been fighting with this error for a few weeks.

You will find these posts intresting

http://forum.doom9.org/showthread.php?s=&threadid=88162

and

http://forum.doom9.org/showthread.php?s=&threadid=75168&perpage=20&pagenumber=6

If you have cce 2.50 give that a try it works fine.