Reencode one VTS and add the result to a previous project

[OB1K]

Hi,

I have a little question. I do a project until the end but when I try to burn the ISO, nero refuse because the size is 4510 Mo. As the limit is 4500, It is impossible.

2 solutions:
- overburning: I never read that the DVD-R is OK in most case so I hesitate. Is somebody often use overburning successfully??

- Reencode one VTS of 188 Mo (below the default limit of 200 in DIF4U): But the problem is that I don't know how to add the result of encoding to the previous encoding. So, I can't create the scenarist script.

At this moment, I deselect the post-process of DIF4U to copy the VIDEO_TS because I already have this copy (with my VTS not encoded) and I launched the batchCCE process.

Is somebody can tell me how to add the resultat with previous result?

THanks for all

[Zeul]

Open the scenaid-ccedata.txt file or the ccedata.txt file in batchcce, deselect all the assets to encode except the one required. Change the average bitrate to a lower value, and encode. This will carry the same naming structure & chapter positions. There is no need to recreate the script because you haven't changed anything.
But scenarist needs to reexamine that new mpv file. So, delete the corresponding vif file in the working directory, and manually drop that new mpv into scenarist. This is to create the new vif only. Now just open the .scn file that was created first time round. Then recompile. Scenarist should now compile normally but use the 'new' mpv file. Delete the oversized vob file from the original VIDEO_TS folder. Run batchifo again, but deselect all the vts's except the one you are redoing. This will process just this vts & move the 'new' vob file into the VIDEO_TS folder. Get VTS sectors. Done. :)

[OB1K]

Thanks for your response. I apply your method and it works perfectly.