[Bug?] RMVB of output lose head and end farames

[lunaticmoon]

Or, Is that I do by force and drive in VirtualDubMod best?

I want to see arrangement and display timing of a frame or to know whether the frame of the beginning and the last is processed exactly.

[Sirber]

AVISynth and VDubMod maybe? :confused:

[karl_lillevold]

Avisynth and VirtualDub would be the best tools. It is sometimes useful to 'StackVertical' (or horizontal) two clips side-by-side and single step frame by frame. One of them can be the original. You can single step both in VirtualDub and MPC. I prefer MPC, since it providesnice full screen stretching.

[damrod]

rmvb analyser maybe??

avisynth also but in directshow mode where are the keyframes/frames ??

[Sirber]

Hum... AVISynth output uncompressed data. All frames are the same, keyframes. :(

[damrod]

but rmvb is vfr no? and with avs we give the framerate so i wonder...

[lunaticmoon]

As a matter of fact, I wanted to know this information for retesting the fault shown in our community.

When it encodes by ERMP etc., one frame of the beginning of an video and the last falls out. That is, when joining together, lack of two frames is made at a knot.

In processing hybrid material manually, this poses a problem in that gap with a sound arises.

He claims that it will be the fault of Producer.

Possibly, is this known fault? :confused:

[lunaticmoon]

I tried the surveillance with VirtualDubMod.
RMVB was not able to be read directly.
Although warning was able to be come out of and read when wrapped in MKV, the picture did not come out.

And...When it encoded to RMVB, it checked visually that the last one frame was missing by chance...:(

[lunaticmoon]

3252 As for RMVB after an output, the frame of a head and an end has disappeared.

I posted this to the HelixCommunity. :D

However, doesn't un-arranging according to this have other users? :confused:

[karl_lillevold]

Please also check in RealPlayer, if you can... It may be difficult, since it can not easily single step. It is very likely that these frames are dropped by realmediasplitter.ax, due to "B frame delay", and that the frames are not missing from the bitstream.

[lunaticmoon]

@karl_lillevold

I am not going to use B-frames of RV10.
The check of B-frames is turned OFF by ERMP.

Although it reproduced by RealPlayer10, it viewed too that one end frame was missing.

It is not displayed although only one deep-black frame is specifically put in after frame which the picture of video finished.

Is it better to send RMVB of an output to you?

[Sirber]

You should use BFrames, in general quality is higher since more bits are saved.