No way! Version 0 .59 can do multiangle?

[dvdnoob]

I am testing it on The Others right now. The usual warning did not pop up saying that it can't so this is a good sign! *cross fingers*

Did Jdobbs sneak one by us? :confused:

[Cwluc]

does it work? would like to know how it ended up.

[FreQi]

I just nabbed v0.59, loaded up Invader ZIM Season 1, Volume 1 and got the "this material contains multiple angles and/or interleaving and is not supported" message.

[jdobbs]

No. It doesn't work. A portion of the code is written and is in v0.59 -- but you have to know how to get to it... and it will only do a portion of the multiple angle processing.

[Doom9]

@jdobbs: the day you release a version with full multiangle support, I'm going to draw a big X on my ceiling :) So far except for the transcoders, nobody really managed to get this done using high quality encoders.

[Fr4nz]

Cmon J we're all with you! :D

[dvdnoob]

*DOH* It didn't work. After 200 minutes it completed the Phase II Encoding. But when it gets to Phase III Rebuild, that's when I get Error #0003.

@FreQi: I had the same message pops up with other version prior to this. May be Jdobbs removed the warning in anticipation of the next release? *cross finger*

By the way, I did a search on Error #0003 and found some reference to DVDRemake. I don'd do any pre or post processing to The Others and still get the error.

Back to the drawing board.

[btspm]

@jdobbs

Not to be too pushy, but can you give us a general ETA on when multiangle will be fully implemented? Just whether it will be a matter of days/weeks or weeks/months. We all appreciate your hard work, but the suspense is killing us!

[TheSeeker]

@Doom9

What about the Big 3??? Doesnt that have full multiangle/seamless branching support? And that uses CCE.

[Trahald]

Originally posted by TheSeeker
@Doom9

What about the Big 3??? Doesnt that have full multiangle/seamless branching support? And that uses CCE.

Multiangle yes.. seamless branching.. no.. at least not full support (scenarist doesnt support ilvu for multistory) when there is seamless branching the output is close but not exact.

[jdobbs]

Originally posted by dvdnoob
*DOH* It didn't work. After 200 minutes it completed the Phase II Encoding. But when it gets to Phase III Rebuild, that's when I get Error #0003.

@FreQi: I had the same message pops up with other version prior to this. May be Jdobbs removed the warning in anticipation of the next release? *cross finger*

By the way, I did a search on Error #0003 and found some reference to DVDRemake. I don'd do any pre or post processing to The Others and still get the error.

Back to the drawing board. The message only pops up when you attempt to open it. If you exit and come back in, and the path is already in the INI, it allows it to process -- I need to fix that.

[jdobbs]

Originally posted by btspm
@jdobbs

Not to be too pushy, but can you give us a general ETA on when multiangle will be fully implemented? Just whether it will be a matter of days/weeks or weeks/months. We all appreciate your hard work, but the suspense is killing us! All I can say is "when its done" -- my time is limited lately. It should have been done already.