Undoing Nandubs 1152 BlockAlign Value?

[TheDJ®]

Hi,

Just been trying the new version of D2S, and after Audio Extraction starts, i get the below message;

Undoing Nandubs 1152 BlockAlign value to 1
Redoing Nandubs 1152 BlockAlign value
Audio extraction finished.

Then during the muxing stage, D2S fails to find the mp2 file?

Anyone seen that above message before and wot i can do about it? With old versions of D2S, i dont get the above, and encodes are fine, but problems with the latest build.

Thx in advance.

DJ.

[Nick]

That message is quite normal.
The new build of DVD2SVCD gives you a choice for how audio is extracted. You can use internal routines (as per older versions) or you can use VfW (Video for Windows) routines, which is the default in the new build.

If you select VFW in the Audio tab you will always get that message about the block align value.


As for your problem, by all means try using internal routines to extract the audio and see if this solves the problem.

If not, your full DVD2SVCD and BeSweet logs would be helpful. Please copy and paste them into a reply to this thread.

Cheers
Nick

[TheDJ®]

Hi Nick, thanks for the reply.

It still encoded ok in the end so it was ok with the nandub message, just didnt encode before, odd!

a little off topic, hope u dont mind, i have never successfully used CCE with D2S, everytime i use it i get errors, like "could not find ecl file". I've tried different versions from 2.5 up til 2.67 with no luck.

any idea's please?

thx

DJ.

[Nick]

v2.5 should work OK :confused:

Later versions you will need a program called eclCCE - a forum search should find it, be sure to get the latest version.

Cheers
Nick

[TheDJ®]

Hi Nick, thanks for the tip, i already have the eclCCE file, so will give it a go.

Cheers for the advice.
DJ.