DVD-RB 0.55 audio state

[djackson]

I've just noticed a prob (or is it just me) with the 0.55 build.

Was preparing a batch conversion for an over night run.

Created and saved the project, reloaded the project, and noticed all audio streams have been toggled. So where I selected all but the DTS stream, now I'm getting only the DTS stream checked. Also in setup I've got "english" checked as the language to keep, but all but "english" is being selected.

eg: All R4 PAL
Never Say Never Again (only has AC3 english, after save/reload no stream selected)
13 Days Disc1 (has AC3, DTS, 2x2ch (all english), after save/reload only DTS stream selected)
Patriot Games (AC3 & DTS english, after save/reload only DTS stream selected)
Sum of all Fears (AC3 english & hungarian, 2x2ch, after save/reload only hungarian stream selected)

Deleted the DVD-RB ini file, and recreated the projects, now all streams are being kept, no mater what the setup selections are.

Regards,
David

[Joergen]

Audio selections are not saved into the project files methinks.. I hope they will soon.

[jdobbs]

Right now the defaults (what you have set in setup) are being saved with the project file. I have plans to save the on-screen selections also. It hasn't been completed yet.

[djackson]

Thanks for the reply.

Have just checked between 0.54 and 0.55, prior to 0.55 audio states were OK.

In 0.54 after a project is saved/reloaded the audio states displayed are the same.
But in 0.55 after a save/reload the audio states are toggled for DTS and non-prefered language from setup.

Had to go back and check as I'd not seen this before.

[jdobbs]

Just realized I have some partially implemented code associated with saving the audio selections in projects... I'll look at it and possibly load a fix later today.

[jdobbs]

Just uploaded a fix. Saving and loading the status of the on-screen selections is now fully supported in project files.

[djackson]

Thanks for the quick response.