CCE popping up

[jamangie]

Is there a way to stop CCE popping up each time it starts each new encode because although I've selected to run minimized, it still keeps popping up. I'm using 0.45 still
Also, is there a way of restarting from where you left off, if the process gets interupted at all
Thanx

[DirtyAbdul]

Originally posted by jamangie
Is there a way to stop CCE popping up each time it starts each new encode because although I've selected to run minimized, it still keeps popping up. I'm using 0.45 still
Also, is there a way of restarting from where you left off, if the process gets interupted at all
Thanx

the same happens to me, too, which i already mentioned in a different thread. jdobbs wanted to look into this. those pop-ups are a little bit annoying, especially while watching TV... :rolleyes:

DA

[RB]

What version of CCE are you using? I think the "run minimized" will work only when you (have to) use EclCCE, that is, you are using CCE-SP 2.66/2.67 trial.

[jamangie]

I'm using CCE 2.67.00.11

[DocDragon]

Originally posted by RB
What version of CCE are you using? I think the "run minimized" will work only when you (have to) use EclCCE, that is, you are using CCE-SP 2.66/2.67 trial.

hmm, i'm using CCE basic v2.67.01.19/v2.69.01.04. but why then was CCE minimized at the very beginning? it only kept popping up from the moment i restored the cce window (just to take a look at the progress report). CCE never minimized again from that point on. DVD-RB and the computer have been shut down/restarted/reset etc. plenty of times since then... :confused:

DD

[CyberCouf]

I'm using DVD-RB 0.62 width CCE SP 2.67, and the option "run minimized" seems not working :(

must I use EclCCE :confused: