D9 to DLT, How???

[Queenie]

Hello everybody,:confused:

It’s appreciated that you can give me some advices about blow question.

D9 DVD copy to hard disk via DVD Decrypter, and then changed region code by IFOEDIT, in order to get normal run in hard disk with POWERDVD AND WINDVD. I want to make the DVD into an IMG and write into two DLT

Pls. I want to know that which software could do that. In addition, How to set the dual layer point for D9?
Thanks a lot!

[Arky]

Queenie, I appreciate that the technical side of your question is valid, but I refuse to answer your question on the basis that I believe it violates Doom9 Forum Rule No.6 (http://forum.doom9.org/forum-rules.htm) in so much that your intentions sound highly questionable - "6) No...illegally obtained copyrighted content!...or asking for help/helping to process such content in any way or form is not tolerated.". I can think of only one reason why someone would need to decrypt a DVD9 and then send it to DLT (obviously for subsequent replication).

Doom9 forums are not here to assist piracy. Please do not post such questions here again.

If my conclusion is wrong, then I apologise.

However, I am going to go ahead and strike you for this. We cannot, and will not, tolerate piracy questions on these forums. I hope you will carefully reconsider your reasons for joining the Doom9 community, and, if you decide you would like to stay, respect the forum rules. If you do so, you will be welcomed by our membership. If you do not then let me save us both some bother and tell you now that you are wasting your time and will not be tolerated.


Arky.