Enabling b+q+g...?

[FSB-SPY]

Either it was a registry fluke after I installed the latest GKnot, or some setting is eluding me at the moment (after I hit 'use defaults' to reset them). I just cannot seem to enable all 3 options using slowest mode in the DivX control panel. Can I change them via registry and then verify visually that they are ticked on the settings panel of DivX?

PS: v5.1.1

PPS: Also have PV enabled.

[jggimi]

I recommend the DivX 5.1 Guide (http://www.divx.com/support/guides/DivXGuide51.pdf), which describes the limitations on using certain features in certain modes. For example, on page 54, you can see that QPel is not supported in Slowest mode.

[FSB-SPY]

I had it ticked on before... not supported but possible, no? In any case, I cannot seem to tick anything other than b-frames anyway. It is the only one that isn't greyed out. About to pull out my hair. :)

Don't have Adobe Acrobat.. :P

[jggimi]

Ah, well, in that case, make sure that Disable profiles is checked in the first page of the Profile Wizard. (See page 79 of the same DivX document.)