Mixed Source...

[insane822]

I have a mixed source video..., film in the beginning (which would be 23.976 ivtc.., then all interlace after that, which is 29.97. Now is there a way for the film part to play back progressive and still keep the interlace part at 29.97? Hope this makes sense..:confused:... Thanks.

[RB]

In CCE's encode settings, check "3:2 pulldown detection". That should do it.

[insane822]

it plays back interlaced and really bad looking. so, the intro is telecined film, then interlace after that. It should work?

[RB]

Yes, read the CCE manual on that. Requires CCE 2.66 or higher. Also make sure you uncheck "progressive frames" and set scanning order to "alternate" in Quality Settings.

[insane822]

I'll have a look and try that again..... thanks.

[insane822]

So, is this supposed to encode at 29.97fps, and then perform inverse 3:2 pulldown when possible (the telecined film scene), and play the rest back in 29.97 interlace? I tried what you said, seems to be same thing... Manual doesn't give much detail about it........ Thanks a million.:rolleyes:

[RB]

Originally posted by insane822
So, is this supposed to encode at 29.97fps, and then perform inverse 3:2 pulldown when possible (the telecined film scene), and play the rest back in 29.97 interlace?
AFAIK, yes. Note, you must not run pulldown against the .M2V file when "3:2 pulldown detection" is checked.