I haave my sonydru510a and DVD rom set to master. I want to burn on the fly directly

[Bluerain]

Hi all

I hope this makes sense I'm new at this.

I have my sony dru510a and DVD rom set to master. I want to burn on the fly directly from the dvd rom to sony.

When i test the dvd ( to make sure it plays in both drives )it plays using the sony ,but when i put the dvd in the Lite on dvd rom it says in "Disc mode" using power dvd xp and freezes.I checked off the box for that drive ,but it won't play.

What could the problem be?

I can't start burning my dvds without the lite on dvd rom working ,so any help would be nice.

Thanks so much
Deborah

[|minister]

why not make an .iso with DVDdecrypter and then burn?

[Bluerain]

First i like to get my dvd rom working!

So, sholud they both be master or not? I'll figure out the burning later,but now i want my dvd rom working.

Thanks

Deborah

[mrbass]

as long as dvd-rom and burner are on separate channels with both set to DMA it should be a no brainer. I've burner 4X on-the-fly.
here's my setup (as far as which IDE channels, etc.)
http://www.mrbass.org/systems/

and here's my guide how to burn on-the-fly
http://www.mrbass.org/dvdburn/

[The Edge]

Originally posted by Bluerain
Hi all

I have my sony dru510a and DVD rom set to master. I want to burn on the fly directly from the dvd rom to sony.

You have both drives set to master?
Should be master and slave.
For me, my toshiba dvd is master and my pioneer A06 burner is slave on the same cable.

Other than that has already been said. (both set to DMA)
Good luck.

Edge