IFOUpdate V0.72 problem

[PL]

Hello,

After going a few searches I found 1 hit on this topic and it was basicly unresolved, but I am also using a diffrent method. Anyway
I have used DIF4U, then CCE and scenarist so far. I'm 100% I have the DVD built correctly in scenarist, buy when I go to updaye my original ifo(s), I get this error message:
ERROR: Original/New Cell counts dont match Aborting

but above that it states:
- New authored IFO has 3 PGCs
- Original IFO has 3 PGCs
- VTS_C table transfered.
- Adjusting authored file.
Aborted. Original File restored.

I seen a suggestion that I should be in adjusted cell mode, but I already am :)

Thanks for any help!

[oddyseus]

There is nothing wrong with your pgc count, the problem lays with the cell count (chapter points). U have more than the original.

Adjusted cell mode is used when u don't want to go through the hassle of defining all the pgcs and cells in a structure. U just define the correct cells and leave the details to it. It seems that u have undertaken this task already, so Ifoupdate is confused cause it expects to find one pgc and finds 3 of them.

[PL]

So with that in mind I should use standard or single cell mode?

[oddyseus]

Yes, quite right. If the structure is identical to the original you must use standard mode.