@DanniDin: BeSweet GUI 0.6b75 won't keep gain in commandline

[Boulder]

As above.

I start the GUI, make my selections including normalizing to 100% (PreGain), encode a file. Close the program and start it again and the portion -ota( -g max ) is missing from the command line although it's enabled in the GUI itself.

I'm using WinXP SP1, if that's of any use. Thanks for any help, a fine proggie it is:)

[DanniDin]

Was it OK in Earlier Versions?

What is the Default Profile After You Close the Program?

Copy and Paste from 'DD-Profiles.ini'

[BeSweet]
~~~~~ Default Profile ~~~~~=.....

[Boulder]

I recall it was OK in b70.

Here's the ini-file:


[BeSweet]
~~~~~ Default Profile ~~~~~=-ota( -g max ) -mp2enc( -m s -p 2 -b 128 -e )

So the ini-file is correct but somehow when the GUI loads, it forgets about the normalizing:confused:

[DanniDin]

1. Click "Copy Command to Clipboard" After the GUI Loads That Profile.
2. Post Your "Ctrl-V"

[Boulder]

Here it is:

"C:\Utils\BeSweet\BeSweet.exe" -core( -input "d:\Temp\Imaget\Trek\trek.wav" -output "d:\Temp\Imaget\Trek\trek.mp2" -logfile "C:\Utils\BeSweet\BeSweet.log" ) -ota( -g max ) -mp2enc( -m s -p 2 -b 128 -e ) -profile( ~~~~~ Default Profile ~~~~~ )

After saving the profile and restarting the GUI:

"C:\Utils\BeSweet\BeSweet.exe" -core( -input "d:\Temp\Imaget\Trek\trek.wav" -output "d:\Temp\Imaget\Trek\trek.mp2" -logfile "C:\Utils\BeSweet\BeSweet.log" ) -mp2enc( -m s -p 2 -b 128 -e ) -profile( ~~~~~ Default Profile ~~~~~ )

[DanniDin]

Thanks for Your Posts :)

I'll Have to Check it More Closely Because I Don't Have This Problem.

Danni.

[DanniDin]

It Only Happens When the Input is Different Than vob/ac3.
I Fixed It.

I'll Release It Next Week After "Crushing" More Bugs.

[Boulder]

Thanks, it's much appreciated:)