Fox Mulder
1st December 2002, 06:49
When I try to do .lst or .ac3 to .mp2 I receive the following error:
BeSweet v1.4 by DSPguru.
--------------------------
Using azid.dll v1.8 (b825) by Midas (midas@egon.gyaloglo.hu).
Using Shibatch.dll v0.2 by Naoki Shibata & DSPguru (shibatch.sourceforge.net).
Using MP2enc.dll v1.129 (23/5/2002), Engine 1.129 <http://www.cdex.n3.net>.
Logging start : 12/01/02 , 02:12:09.
C:\BeSweet 1.4\BeSweet.exe -core( -input d:\VIDEO_TS\CSC AC3 T01 2_0ch 192Kbps DELAY -66ms.ac3 -output d:\VIDEO_TS\CSC.mp2 -logfile C:\BESWEET 1.4\BeSweet.log ) -azid( -s surround2 -c normal -L -3db --maximize ) -ssrc( --rate 11025 ) -2lame( -m m -b 64 -e )
[00:00:00:000] +------- BeSweet -----
[00:00:00:000] | Input : d:\VIDEO_TS\CSC AC3 T01 2_0ch 192Kbps DELAY -66ms.ac3
[00:00:00:000] | Output: d:\VIDEO_TS\CSC.mp2
[00:00:00:000] | Floating-Point Process: Yes
Error 47: Error with LAME dll!
Quiting...
[00:00:00:000] Conversion Completed !
Logging ends : 12/01/02 , 02:15:05.
BeSweet reports the error right after the gain search is completed.
Any advice? I can't seem to find this issue commented before. Thanks in advance.
BeSweet v1.4 by DSPguru.
--------------------------
Using azid.dll v1.8 (b825) by Midas (midas@egon.gyaloglo.hu).
Using Shibatch.dll v0.2 by Naoki Shibata & DSPguru (shibatch.sourceforge.net).
Using MP2enc.dll v1.129 (23/5/2002), Engine 1.129 <http://www.cdex.n3.net>.
Logging start : 12/01/02 , 02:12:09.
C:\BeSweet 1.4\BeSweet.exe -core( -input d:\VIDEO_TS\CSC AC3 T01 2_0ch 192Kbps DELAY -66ms.ac3 -output d:\VIDEO_TS\CSC.mp2 -logfile C:\BESWEET 1.4\BeSweet.log ) -azid( -s surround2 -c normal -L -3db --maximize ) -ssrc( --rate 11025 ) -2lame( -m m -b 64 -e )
[00:00:00:000] +------- BeSweet -----
[00:00:00:000] | Input : d:\VIDEO_TS\CSC AC3 T01 2_0ch 192Kbps DELAY -66ms.ac3
[00:00:00:000] | Output: d:\VIDEO_TS\CSC.mp2
[00:00:00:000] | Floating-Point Process: Yes
Error 47: Error with LAME dll!
Quiting...
[00:00:00:000] Conversion Completed !
Logging ends : 12/01/02 , 02:15:05.
BeSweet reports the error right after the gain search is completed.
Any advice? I can't seem to find this issue commented before. Thanks in advance.