CCE cuts end of the movie off.

[flaystus]

Trying to backup a movie and my usual method goes wrong for some reason.

The file I get is the correct legnth (a little over 2 hours) if import it into DVDMaestro... but its not been reencoded yet.

After reincode with CCE is finished its only about 1 hour and 45 min long...

This has happened with 2 movies so far.

Any ideas?

Oh yeah I'm using DVD2DVDR to rip the streams then encoding them with CCE and loading them into DVDMaestro (cause Scenarist crashes no matter what I do for some reason) When I encode I'm using the script/setting file the DVD2DVDR makes for me.

Figureing that was the problem I tried to encode from scratch using the Getting the best out of CCE guide on this site... same issue. HELP!!! :confused:

[flaystus]

Duh I'm stupid... the guide does not do this. Seems the problem was caused because the ECL file I had gave the incorrect end frames. (Ended at frame 260000 or something like that instead of the actual end of the file)

I have a way to look up the end frames but its a very slow round about method... anyone know the easiest way to check this?

[auenf]

find out the time in seconds and multiply it by 25, 23.976 or 29.97?

Enf...

[Matthew]

If you have the DVD2AVI project file then you could just open it in Gordon Knot and it'll display the no. of frames ;)

[zxsdef]

May seem obvious but are you using win 98 as it only deals with file sizes less than 4 gig