No chapter stops after CCE and Scenarist

[Sp33d]

I just finished Blade 2 using CCE and Scenarist. After the authoring was done, I checked the movie in PowerDVD 4.0. It looks like the movie is all one chapter. Where did I screw up?

[screw]

Did you add chapter points in Scenarist? ScenChap is the right tool to do this. If you just added chapters in CCE, it means nothing to Scenarist - it is just for CCE to correctly put I frames.

Screw

[TRILIGHT]

Screw is correct. You most likely did not create your Scenarist chapter points with ScenChap. The chapter setup in CCE (as mentioned) allows for the forcing of I-frames at those locations. This gives Scenarist the precise I-frame to jump to when you go to create the chapters there. Good luck!

[Sp33d]

Thanks to both of you for the reply's. I will download ScenChap and give it a try. I felt so dumb for not realizing that the movie only had one chapter after authoring. Good thing neither had been burnt.

[screw]

To Sp33d:

This Doom9 page explains all those chapter issues:
http://www.doom9.org/mpg/ifoedit-cce.htm

Good luck.

Screw