TonyTony
18th May 2002, 21:01
Hi
Had a DFI mother board with 1800 athlon xp
Just replaced the mother board with EPOX 8k7A+.
With the DFI board and TMPG 2.52.34.19, In the
enviromental settings i'm positive that in the
CPU tab, SSE was available.
With the EPOX board this is not available.
Also in settings-Quantize matix,Use floating point DCT
was always active.
It seems to take about 2 - 3hrs longer to rencode a 150 minute
film!
Any one got any ideas as i am not well knowlegable regarding
the setting up of Athlon boards and processors
Thanks in advance
Tony
Had a DFI mother board with 1800 athlon xp
Just replaced the mother board with EPOX 8k7A+.
With the DFI board and TMPG 2.52.34.19, In the
enviromental settings i'm positive that in the
CPU tab, SSE was available.
With the EPOX board this is not available.
Also in settings-Quantize matix,Use floating point DCT
was always active.
It seems to take about 2 - 3hrs longer to rencode a 150 minute
film!
Any one got any ideas as i am not well knowlegable regarding
the setting up of Athlon boards and processors
Thanks in advance
Tony