roko
16th February 2002, 23:53
When I run DVD2SVCD 1.06 build 3 or build 4 at CCE stage I get an error saying no frame rate reported something about using 2FPS.
The subwindow opens and puts in the file names. It tries to encode but crashes. Using 1.06 build 1 I have no problem going through this point. It finishes all the way. SVCD play fine.( except audio is a little out of sync,different problem I think). I am using a small .ifo which has about 8 minutes of play time after the program is done. I use the same .ifo for all versions. I have a Athlon 1.1G, 128Mb, Abit KT-7A, 60 Gig drive. I use CCE 2.50. I set the default output folder to the same partition. All other settings are unchanged. I don't touch them. Watching the log during this process everything is fine up to that point on the newer builds. Thanx in advance for any information.
The subwindow opens and puts in the file names. It tries to encode but crashes. Using 1.06 build 1 I have no problem going through this point. It finishes all the way. SVCD play fine.( except audio is a little out of sync,different problem I think). I am using a small .ifo which has about 8 minutes of play time after the program is done. I use the same .ifo for all versions. I have a Athlon 1.1G, 128Mb, Abit KT-7A, 60 Gig drive. I use CCE 2.50. I set the default output folder to the same partition. All other settings are unchanged. I don't touch them. Watching the log during this process everything is fine up to that point on the newer builds. Thanx in advance for any information.