unsupported resolution error in rempeg?

[jarret3]

I searched the forum, and there was a few posts on this issue but no one has seemed to reply to them. I am getting am unsupported resolution error in ReMPEG 1.5.2 when I hit 75% on the first VOB. Has anyone been able to get around this problem. The movie i am getting it on is Gladiator.

Thanks

[mcp]

i have got the same problem with alien4.
first i used a cffl-file to load the vobs into rempeg, 2nd I used vobedit to create a m2v-stream from the film, then imported this into rempeg->same problem...
what should WE do now ?
anyone had this problem before ?
:scared:

[mcp]

-> i´ am currently now working on another thing that should work...
my film stops at the close end, so i am now rempeging only the first 5 vobs and then put the stream into them....
for now my only solution that should work,
-> other thing that i tried today was to re-mpeg the m2v stream with tmpgenc, but this was a disaster...
after 7hours it wrote me a film that was 5minutes to short (that %/"§$"§$%-program!!!)
-> i also have a software called pva strumento, it is a tool with that you can "clean" a bad recorded mpeg2-stream that you have recorded with an setellite dish and computer card, in the proggie there are a lot of options, try them if you like, i´m currently a beginner (owned my recorder three weeks before) and i dn´t really know what i must check or uncheck)
greetings from mcp...and now it will take 9hours...i will post here if it works tomorrow, because my only goal is to rip the alien4 ...

[mcp]

my film now works like the method i told u one posting before...
currently watching alien4
hope that the re-mpeg author will make a update that will correct "these" problem...
ciao,mcp
:D :D :D :D