Bd-rebuilder: Target bd-25 output turns out 1.61 GB?

[Nerz]

I'm not sure what, if anything I'm doing wrong. With output options set to bd-25, after the encode the folder created for the movie only comes to a 1.61 gb folder. The workfiles folder is 16.7gb. I thought it could be small outputs because it was "movie-only", therefore tried full-backup and that output became the sizes described. any suggestions? Could it be my error or should it go in the bugs report?

[datman]

I'm no expert but you have somethig setup wrong. Or something in your computer. Do you have a lot of software loaded. I would reinstall all the required software from page 1. Then make sure no other programs are running and try it again