Procoder 3 and DVD-RB pro question

[Sworm]

Hi all,
i'm downloading the procoder 3 demo, i want to try it and if i like i'll buy procoder too.

For use canopus procoder with DVD-RB Pro , i have only need to install procoder 3 ? Or there's some other setting to make in ProCoder 3?

[wmansir]

You have to install Procoder and then setup EclPro. This can be setup by the DVD-RB installer if Procoder is already installed, or if you start a DVD-RB job with Procoder selected as the encoder, or you can manually configure it under the Encoders/EclPro folder in DVD-RB's install folder. If your DVD-RB doesn't have an EclPro folder you should reinstall it and make sure EclPro is selected.

[six13]

I have been trying to get Procoder 3 to work with the free version of DVD-RB. I have downloaded EclProv1.10 and set it as the path for DVD-RB and selected procoder in the mode of DVD-RB. Can't get it to work with DVD-RB, have been using HCenc but wanted to set Procoder 3 as the encoder now as many of my sources are interlaced. When DVD-RB runs I get all the setup questions about quality, GOP, minize encoder, ect... but doesn't work.

Any information would be appreciated.

Thankyou,

Six13