DVD-Rebuilder to encode a small part of a ripped DVD

[stenews]

Hi to everyone,
I'm a DVD-Rebuilder user and may be someone else already asked a question like that but...
...I don't remember exactly where I read it so I'll try to ask you again.

How can I encode just one "clip", I mean a small part, of a previously full ripped DVD?
In case I can't do that with DVD-Rebuilder, can I even use DVD2SVCD to do that? If yes how?

Thanks,
Stefano

[Groucho2004]

I have successfully used good old DVDShrink (authoring mode, specify start/end frames) to extract small clips in order to test DVD Rebuilder.

[stenews]

Hi Groucho2004 and thanks for your reply

I see your point...but have you never used DVD-Rebuilder or DVD2SVCD to extract those small clips?
I read somewhere the way to do that, but I can't remember where.

[dialysis1]

Are you thinking of the force reencoding (for filters) option?
Or maybe you're looking to blank segments?

[stenews]

Hi dialysis1 and thanks for your help too.

Is it an option of DVD-Rebuilder or what?
I never used it, what this option does?

Thanks!

P.S.
I just find out the option you was talking about but unfortunately I don't think we're in the right way with that!

[dialysis1]

Your posts are a bit confusing.
Are you taking a movie and looking to output a small clip or do you already have a small clip and looking to reencode it?
You can blank most of the movie leaving only a portion of it but it may not have the start and end points that you desire. For that, it's best to use DVD Shrink as mentioned by Groucho2004.

[stenews]

well...confusing?
I don't think so...BTW what I'm looking for is the right procedure to encode (extract) just a small clip from a full ripped DVD instead of just the full one.
of course using DVD-Rebuilder...