VobBlanker causes lagging after cut

[SUPERIOR]

I used VobBlanker to delete some scenes
imported VTS file and picked PGC and chose cell I wanted
gave mark for begin and one for end and activate "Cut"
I got warning about cutting inside without splitting cell
I clicked continue(I didn't use split cell coz of former problem I had raised it before, about interfering frames where cut takes place)

click ok then process, after finished I tried to play movie everything was so normal until I tried to speed up forward :mad:

the movie began to lagging at scene where I had deleted for 1-2 sec

and same problem went when I tried to do backward

but when I play movie normally (means at normal speed) nothing wrong pops

so what I have to do now??

Thanks in Advance

[setarip_old]

Hi!I got warning about cutting inside without splitting cellSeems almost obvious that this is very likely the cause of your playback problem...

[blutach]

Rebuild the timemap. Do this in PgcEdit.

Regards

[SUPERIOR]

@setarip_old thanks but I know this, so I asked the question
@Blutach thanks for advise but I tried it, not working, I really did remap time but I got one notice may help
after I deleted the scene, first the time was different as it down alittle but after I remaped it got back as if I hadn't done anything
I mean time is still equal to original

is there any solution??

[blutach]

After cuts, I tend to demux and remux with muxman. This always works as it rebuilds the title from scratch.

Regards

[SUPERIOR]

@blutach you are my hero
I thought about this shot, I'll try it and feedback

thanks alot

[SUPERIOR]

ok...I did what you told me @blutach and it's working 100%
thanks so much

[blutach]

http://www.digital-digest.com/~blutach/yer.gif