swestner
22nd March 2008, 01:29
Hello,
would it be possible to insert the trim in tsremux not only by time but per frame?
I have some ts-records which h264_cutter opens without problem but produces ann error when cutting. The records are played without problem and was remuxed with tsremux. I only want to cut some video at the start and the end.
The cyberlink-Codec reports invalid time so I use cutassistent in a VMware to get accurate trim-points. But if I enter these trim-points in minutes and seconds tsremux (9:37 - 16:45) tsremux produeces only a 2-minute-video. It seems that it calculate the trim using the codec-delivered time.
If I could set the trim-point at frame-level (12959 - 23649) I think that the trim will work fine.
Is there a way to do this?
Thanks
Stefan
would it be possible to insert the trim in tsremux not only by time but per frame?
I have some ts-records which h264_cutter opens without problem but produces ann error when cutting. The records are played without problem and was remuxed with tsremux. I only want to cut some video at the start and the end.
The cyberlink-Codec reports invalid time so I use cutassistent in a VMware to get accurate trim-points. But if I enter these trim-points in minutes and seconds tsremux (9:37 - 16:45) tsremux produeces only a 2-minute-video. It seems that it calculate the trim using the codec-delivered time.
If I could set the trim-point at frame-level (12959 - 23649) I think that the trim will work fine.
Is there a way to do this?
Thanks
Stefan