Problem with DVD playback in Zoomplayer.

[SUPERBIF]

Hi, I've just started using this excellent Zoomplayer program, and got it configured almost perfect.
I'm only missing one thing, which is to get it to register ffdshow.ax correct.
I have tried start>run regsvr32.exe /u "c:\program files\ffdshow\ffdshow.ax" and start>run regsvr32.exe "c:\program files\ffdshow\ffdshow.ax" but still nothing.
I have tried to unistall and install a never version of FFDShow but still the same.
The funny thing is it always comes with the screen: You must first setup DVD playback so that it would work properly on your system. I press okay, go and select FFDshow video and audio decoder and press okay, and then it I can get it to use FFDShow with ONLY that DVD. Next time the screen appears again.

What can I do to get it to work properly without entering the setup screen each time.
I would really like to keep my current version FFD and settings, because the PQ are not as good (I know it should be that way) in the new version I have tried.

Is there perhaps some way to trick it to get it to remember my FFDShow decoder in DVD setup without registrating the filter next time, so I don't have to set the decoder each time.

PS. Apart from that problem Zoomplayer rocks!

[foxyshadis]

It sounds as if all the codecs are set up properly, but that your settings aren't being saved. All of the settings are saved in the registry to HKEY_CURRENT_USER\Software\VirtuaMedia\ZoomPlayer, perhaps there's a problem writing to it?

[bjur]

Okay. When I only says verify I get the message that they are registered correctly, so how do I get it to save properly?

[KoD]

After you configure your options in ZoomPlayer, press "Apply" and then "Ok". That should save the options.

[bjur]

Have also tried, but no luck:(
Any other ideas, perhaps is there a way to get to reg. DB and save from that?