zcodec
21st October 2007, 23:45
Greetings
Does anyone happen to own a Canon iP4500? well I'm not sure if this problem is the same for other modules also, but whenever attempting to print directly onto disc going through the software provided, the result leaves an un-printed gap about half a cm by the inner circle. Why doesn't it print to the very end of the printing area on the disc like expected? This pretty much goes against the whole point. I attempted to adjust this with the circle size settings, but it won't allow any less than -10.0. The printer is perfect except this one very annoying thing.
Thanks for any help.
Does anyone happen to own a Canon iP4500? well I'm not sure if this problem is the same for other modules also, but whenever attempting to print directly onto disc going through the software provided, the result leaves an un-printed gap about half a cm by the inner circle. Why doesn't it print to the very end of the printing area on the disc like expected? This pretty much goes against the whole point. I attempted to adjust this with the circle size settings, but it won't allow any less than -10.0. The printer is perfect except this one very annoying thing.
Thanks for any help.