gargoyle47
8th February 2007, 19:23
I have been testing out a Hauppuage card.
I installed all of the software related to the card.
I started off using WinTv2000 to capture vhs tape.
I was going through the different setting to determine which were support by the card.
I was able to go through all of the setting and capture a file.
Then I tried the Amcap program that was inititally installed with the capture card. I tried to run it but it hung up and would not respond.
It seem since this happen I can not use the WinTv2000 to capture anything.
If I start a capture it gives me the following error:
Stream Dshow error
RunGraph: Run () failed the system can not find the path specifed
(0x8007003)
I have tried to search for a solution or explaination to this problem but I have come up empty.
Do you need more information? Can you help?
I installed all of the software related to the card.
I started off using WinTv2000 to capture vhs tape.
I was going through the different setting to determine which were support by the card.
I was able to go through all of the setting and capture a file.
Then I tried the Amcap program that was inititally installed with the capture card. I tried to run it but it hung up and would not respond.
It seem since this happen I can not use the WinTv2000 to capture anything.
If I start a capture it gives me the following error:
Stream Dshow error
RunGraph: Run () failed the system can not find the path specifed
(0x8007003)
I have tried to search for a solution or explaination to this problem but I have come up empty.
Do you need more information? Can you help?