Language issue while using RB

[BigCondor]

Thanks for the wonderful program. I like your program but it took me nearly half a year in the past before I could really use your porgram. Every I got an error massage just because I had not change the language to English in the Advance tab of the Area and Language in the Control Panel.
So every time I use your program I will have to do the above process and reboot. After the job is done then I'll have to change back my system to Chinese. This also happens when I try to launch IFO Update.

So, do you have any plan to let the program works even on other languages? Thanks!

[jdobbs]

If your system is set up for some Asian languages, you have to select a western language under the "Language for non-Unicode Programs" setting in "Languages" in order to make it work. Unfortunately the program was very far along before it became known that this was even an issue.

I looked at it, and it would require an almost complete rewrite -- and I couldn't justify that much work based upon the low number of reports (I think I've had it reported three times total).

Sorry.

[BigCondor]

Not at all, I do actually have some experience of programming and I understand how hard to handle those lines. A little trouble wouldn't hinder me from using a great program, thanks for the reply!