Replace a dummy track with Scenarist

[sonofsmog]

Prolly a noobie post, but any help would be greatly appreciated.

I used the big three to backup Swordfish. Everything looked fine until I noticed that the Warner Logo had no audio. Looked in Scenarist and noticed that it had been replaced by a dummy track. Apparently it was never demuxed for whatever reason. How hard is it for me to just demux this track and replace it in Scenarist. Do I do it in the track editor or the data editor?

---

[Zeul]

the demuxed audio is dropped into the data editor first. You must then set the correct droptype if NTSC. (look at the video file). The delete the dummy audio from the correct track and drag&drop the new demuxed audio from the data editor onto the track. Make sure the start_time_to_video of the audio is set to 00:00:00:00.

[sonofsmog]

the demuxed audio is dropped into the data editor first. You must then set the correct droptype if NTSC. (look at the video file). The delete the dummy audio from the correct track and drag&drop the new demuxed audio from the data editor onto the track. Make sure the start_time_to_video of the audio is set to 00:00:00:00.


I tried this. I deleted the dummy tracks. Dropped the demuxed audio into the data editor, and drug it into the track editor. No problem. However, now when I try to drag the dummy audio tracks that were originally present back in i get an ""AC3 Audio "VTS02_2_80""'s resolution or drop type does not match with the existing data." error even though the dummy tracks have the same drop type, and resolution as the real tracks.

:(