AutoRV10 Volume level

[^_^x]

first::::
it's just a suggestion for autorv10 to add feature set volume level.

i found this feature on DVDPean, and thought it would be nice if placed on autorv10.


second::::
actually, i try this ways to encode dvd:
----------------------------------------------
1. rip dvd
2. convert audio to wav with DVDPean by increasing volume level
3. convert wav to aac+v2 with BeLight installed on realaninme(some times i still use this software)
4. convert video to rmvb with autorv10
5. extract subtitle, with vobsub
6. mux audio, video, subtitle, chapter to mkv

since it's a DVD, seem not cool just encode to rmvb with only support one subtitle and one audio. smil????, na..na..na!!!!

maybe it's the time for autorv10 migrate to mkv or another one, but keep that rmvb.

Ok, tha's a litle suggestion
sory my bad english

[Dark-Cracker]

hi,

thank u for your suggestion.
second here is a simple way to do your task :

1. Rip the DVD using the autorv10 panel
2. Convert audio using autorv10 (use the boost param to adjust the audio level)
3. Encode the audio in RAAC (it's AAC+ codec but wrapped in RV10, and it's better than nero audio IMHO)
4. same as you :)
5. Extract subtitle and chapters using autorv10 (you can also extrac a specified subtitle using autorv10 if you choose a vobsub input source).
6. same as you again.

PS : add at your desired final size a +1% because matroska remove a part of the header.

perhaps later i will think to add a full matroska support.

Have a good day ++.

[^_^x]

thank's for your autorv10 ^_^v