encoding subceeding segment fails when...

[DK]

i experienced the following problem/bug:

- saved two projects

- started batch routine

- a few seconds after starting i wanted to make sure that i had *shutdown* activated and thus clicked on FILE in rb 1.05

- getting up this morning i found my machine and rb still running and only having finished some 5%
i.e. the first segment was encoded but because i clicked on FILE the following segment(s) were not

- clicking inside rb or anywhere else made rb carry on


as i had never done so before i updated to 1.051, loaded the very project again and retried this phenomenon

clicking FILE and not touching the mouse afterwards the current segment will be finished but the next one wont be started

tested with rb 1.05 + 1.051 and procoder2

[jdobbs]

Hmm.. I'll check on it, but I think that's a Windows thing. It's awaiting input from the menu selection. The current file gets completed only because it is being processed by another program (in your case, ProCoder).

[l8nights]

I've noticed that scrolling through the log in certain skins will also pause the operations from proceeding past it's current postion til I release it but I haven't been that annoyed by it!

this was the same w/ cce hc and even rebuilding segments w/ out the encoder running in fact just now tried it while building iso and it paused until I released the log!

this is using your dot noise and aqua skin for sure!