Traxdata 1 Speed DVD-R at 2speed.

[garyjh2000]

Folks,
The story so far:
Windows XP
Pioneer A04 DVD Writer(Various Firmware)
DVD Decrypter
Nero
Instant CD/DVD

I have been trying to burn Traxdata G03 Ritek Disks at 2 speed.
Tried V1.31 and V1.40 but with no joy, can anyone help?

Managed to get back to V1.31 however when trying to burn
DVD-R with DVD-Decrypter on Traxdata Ritek G03 at 1 speed or 2 Speed i get some kind of Addressing error and it wont write the disk.
Thought i would try Instant CD/DVD and i get the following error at 1 Speed and 2 Speed:
Versions:
Operating System: Windows 2000 5.01 (Build 2600: )
InstantCopy: 6.5.2.038 (14/08/2002 17:05:32)
InstantDisc: 6.5.2.076 (14/08/2002 17:06:52)
CD-R Drivers: 6.4.3.064 (12/08/2002 15:53:32)
ISO/UDF Creator: 1.0.2.026 (31/05/2002 17:02:02)
ASAPI Interface: 5.0.0.002 (27/04/2000 13:31:1
ASAPI Driver: 5.0.0.001 (08/01/2000 10:22:36)

Write speed: 1.0x DVD(1,385 kB/s)
Write method: Disc at Once
Closing method: Close disc
Simulation: No Simulation
[ ] Write to hard disk first
[ ] Verify destination media after write

Destination Device:
Pioneer DVD-RW DVR-104 (G 1.40 MMC-Driver

Disc Contents:
Nr Length Pre Post Sectormode
1 1,992,610 150 150 Mode 1 ISO

Project contents:
Datatrack
File systems: ISO9660 Level 1; Joliet; UDF 1.02

Reading destination disc information ...
Creating table of contents...
Writing track 1 of 1 track(s)
Starting track 1...
Resetting destination device...


---------------------------------------------------------

An error occured while writing track 1 at position 797.

---------------------------------------------------------




---------------------------------------------------------

Extended information:
Device: Pioneer DVD-RW DVR-104 (G
MEDIUM ERROR: POWER CALIBRATION AREA ERROR
71 00 03 00 00 00 00 0E 00 00 00 00 73 03
2A 00 00 00 03 1D 00 00 20 00


---------------------------------------------------------


I get similar errors on firmware 1.40, finally reflashed to 1.32 and disks burn successfully at 1 speed only although it defeats the purpose of the exercise.
What the Feck is going on?
Bad Firmware?
Bad Media?
Bad Software?

Should i just leave the firmware at V1.32 and continue burning at 1 speed only.
When i had the original V1.2 firmware other brands of 2 spd disks burned successfully at 2 speed.

Thanks for reading.
Gary