Doom9's Forum - View Single Post - Producer M5: How to enable RV9-EHQ

karl_lillevold · 25th July 2003, 03:49

I am really sorry about those encoding jobs. Sometimes it's better to use a Milestone that's been out a few weeks, but I really did not expect this problem. You happened to use normal, which corresponds to the old RV9, with no EHQ.

The mapping is as follows:

very-high: 85
high: 75
normal: 65
fast : 50
very-fast : don't use, need to check

So even the mapping is out of whack from what I would have wanted. it should have been 80, and 70. very-high = 85 will be slower than 80 without much gain in quality. For now, I would recommend just getting the fixed DLL and use your previous method to enable EHQ.

25th July 2003, 03:49	#6 \| Link
karl_lillevold Moderator Join Date: Oct 2002 Location: Seattle Posts: 1,584	I am really sorry about those encoding jobs. Sometimes it's better to use a Milestone that's been out a few weeks, but I really did not expect this problem. You happened to use normal, which corresponds to the old RV9, with no EHQ. The mapping is as follows: very-high: 85 high: 75 normal: 65 fast : 50 very-fast : don't use, need to check So even the mapping is out of whack from what I would have wanted. it should have been 80, and 70. very-high = 85 will be slower than 80 without much gain in quality. For now, I would recommend just getting the fixed DLL and use your previous method to enable EHQ. __________________ This information is provided "AS IS" with no warranties, grants no rights, and reflects my personal opinion.