Doom9's Forum - View Single Post - I am new and I have a few general questions

monohouse · 23rd November 2017, 02:06

I did many tests, I used QTGMC, AAAmod, sangnom2, nnedi3, maa2, daa3 and mcdaa3: none of them reach remotely close to the artifact reduction/sharpness/interlacing elimination qualities of daa3 for this source anyways. the one that did give very good result is TIVTC, very effective, even better in some areas with horizontal lines.

I have a small problem, the process is very long, so I have idea to run the process on another computer, but the computers are not the same, the computer that runs right now has multimedia instructions AVX+2, SSE 1,2,3,3S,4.1,4.2, but the other computer has SSE 1,2,3,4A without AVX, I am asking because I am afraid to loose precision in the process not important for me speed, does AVX/2 give more precision in registers than SSE registers ?

23rd November 2017, 02:06	#10 \| Link
monohouse Registered User Join Date: Jul 2007 Posts: 106	I did many tests, I used QTGMC, AAAmod, sangnom2, nnedi3, maa2, daa3 and mcdaa3: none of them reach remotely close to the artifact reduction/sharpness/interlacing elimination qualities of daa3 for this source anyways. the one that did give very good result is TIVTC, very effective, even better in some areas with horizontal lines. I have a small problem, the process is very long, so I have idea to run the process on another computer, but the computers are not the same, the computer that runs right now has multimedia instructions AVX+2, SSE 1,2,3,3S,4.1,4.2, but the other computer has SSE 1,2,3,4A without AVX, I am asking because I am afraid to loose precision in the process not important for me speed, does AVX/2 give more precision in registers than SSE registers ? Last edited by monohouse; 24th November 2017 at 17:30.