I still cant get fine burns even with this method.
Here are 2 scans, both burned with a PX-716a 1.08 firmware with DVDD @2,4x. The .ISO is being burned from a Raid Raptor Sata controller to a primary IDE controller (PX-716a being master, nothing more plugged in the data cable):
We can consider it good burns, but my problem is that I can maintain a constant low pif like in the 1st pic before layer break.
I see in some reviews burns scans made to these media and I cant almost notice layer break on the graphic. Even from another users wich use the same drive and media used.
What I'm I doing wrong ? Do u think it's the software ? Using imgburn should solve ?