Quote:
Originally Posted by iSunrise
Just do a clean install (you can select that option after you started the driver setup) of the NV driver anyway. If you have problems when you just switched the card, there´s not much else that can go wrong, especially not if you´re still on NV.
|
did clean install with new drivers,going to check it out now. (madvr osd still reports refresh rates that are a bit unstable,its scary)
edit:it seems it works like a charm,reclock reports 72hz(DDR),but madvr goes from 68 to 76hz on 72hz display(lol) (highest noted was about 96hz just at start of playback)
edit2:it works like a charm for some time,around a minute or so,then drops 60 to 70 frames,and the cycle repeats. decoder queue can go as high as 26-26/12 (how is that even possible)
starting the playback after reinstalling LAV filters makes the screen black,and only the audio plays,it shows itself after about 10 seconds. (or in most cases,doesnt show at all)
gpu-z shows no gpu load,or video engine load,but it gets to its highest memory and gpu clock for first ~10 seconds of playback,then goes to normal 2d mode values.
trying to seek while video is blacked out makes mpc-hc freeze.