Quote:
Originally Posted by johnman
The Dialog Normalization is correct if i interpret the manual correctly :
DlgNorm 0 to 31 (-1 dB to -32 dB)
|
From a52 doc:
"Valid values are 1–31. The value of 0 is reserved. The values of 1 to 31 are interpreted as -1 dB to -31 dB with respect to digital 100 percent. If the reserved value of 0 is received, the decoder shall use –31 dB. The value of dialnorm shall affect the sound reproduction level."
There are other errors in Soft Encode help:
CodeMode 1 to 8 (1/0 to 3/2)
may be:
CodeMode 0 to 7 (Ch1 + Ch2, 1/0 to 3/2)
From a52 doc:
"If acmod is 0, then two completely independent program channels (dual mono) are encoded into the bit stream, and are referenced as Ch1, Ch2."
And:
MixLevel 0 to 32 must be 0 to 31 (5 bits field, max 31)
The settings not captured in your Configuration window, taken the default values (not the actual settings in Soft Encode):
BSMode=0 (Complete Main)
CopyRight=1 (set)
Original=1 (set)
RoomType=2 (Small Room, flat monitor)
MixLevel=105 (dB SPL)
Quote:
Originally Posted by johnman
But taken into account all the ON's that should be OFF's and reverse, im not to sure about this either.
|
I'm sure, after many, many test, but you are free to believe me.
May be others users can test this, and post any confirmation.
Another test using 0/1 instead Off/On don't work, the parameter are ignored and use the default.